HP StorageWorks MSL Library Extender user guide (AQ746-96005, September 2009)
Table Of Contents
- HP StorageWorks MSL Library Extender user guide
- Table of Contents
- 1 Features and overview
- 2 Configuring and operating an extended library
- 3 Installing the Library Extender
- Identifying product components
- Downloading product documentation
- Determining the master and lower Library
- Saving the Library configurations
- Upgrading the Library firmware
- Enabling extended mode
- Removing the cartridges from the Libraries
- Powering off the Libraries
- Positioning the Libraries in a rack
- Relocating tape drives
- Removing and replacing drive bay covers
- Removing the USB device and Ethernet cable from the lower Library
- Extending the pull-out tab
- Aligning the Libraries
- Installing the Extender
- Powering on the extended library
- Verifying the installation
- 4 Using diagnostic tools and troubleshooting
- 5 Servicing the Library Extender
- Replacing the Library Extender
- Removing the Library Extender
- Removing a cartridge from the Extender
- Repackaging the Library Extender
- Releasing the magazines manually
- 6 Support and other resources
- A Technical specifications
- B Electrostatic discharge
- C Regulatory compliance notices
- Glossary
- Index
Moving the clip nuts
For the MSL4048 and MSL8096, replace the clip nuts in the locations shown in Figure 15, page 34.
MSL8096MSL4048
Figure 15 Clip nut locations
.
2. Rail screw location1. Clip nut location
4. U marker3. Library bottom
Installing the Library in the rack rails
With assistance, slide the Library onto the metal rails as shown in Figure 16, page 35. Secure the
front bezel to the rack using a #2 Phillips screwdriver placed through the small holes in the mounting
bracket to tighten the captive screws on each side of the Library.
CAUTION:
To avoid personal injury and damage to equipment, obtain adequate assistance to set the Library on
the rails.
Installing the Library Extender34