HP StorageWorks MSL Library Extender user guide (AQ746-96005, September 2009)
Table Of Contents
- HP StorageWorks MSL Library Extender user guide
- Table of Contents
- 1 Features and overview
- 2 Configuring and operating an extended library
- 3 Installing the Library Extender
- Identifying product components
- Downloading product documentation
- Determining the master and lower Library
- Saving the Library configurations
- Upgrading the Library firmware
- Enabling extended mode
- Removing the cartridges from the Libraries
- Powering off the Libraries
- Positioning the Libraries in a rack
- Relocating tape drives
- Removing and replacing drive bay covers
- Removing the USB device and Ethernet cable from the lower Library
- Extending the pull-out tab
- Aligning the Libraries
- Installing the Extender
- Powering on the extended library
- Verifying the installation
- 4 Using diagnostic tools and troubleshooting
- 5 Servicing the Library Extender
- Replacing the Library Extender
- Removing the Library Extender
- Removing a cartridge from the Extender
- Repackaging the Library Extender
- Releasing the magazines manually
- 6 Support and other resources
- A Technical specifications
- B Electrostatic discharge
- C Regulatory compliance notices
- Glossary
- Index
SolutionCauseMessageCode
• Power cycle both Libraries.
• Run the Library Extender
cycle test.
See Table 8, page 50.
Library Extender has reported
an error condition.
BD
• Download the current lib-
rary extender firmware
bundle to update the Librar-
ies to compatible firmware
versions.
• Retry the operation.
The Extender is incompatible
with the Libraries, or the firm-
ware versions on the Libraries
and Extender are incompatible
with each other. See Table
9, page 52.
Extender or library stack incom-
patibility.
BE
Table 6 Sub-codes for error B8
MessageSub-code
Library Extender expected40
Lower Library expected41
Master Library expected42
Table 7 Sub-codes for error B9
MessageSub-code
No device present31
I²C write error32
I²C read error33
Table 8 Sub-codes for error BD
SolutionCauseMessageSub-code
• Power cycle the master
Library.
• Run the Library Extender
cycle test.
• Retry the operation.
The Extender robotic cannot
locate its home position within
the master Library.
Sensor master home not found.01
• Power cycle the lower Lib-
rary.
• Run the Library Extender
cycle test.
• Retry the operation.
The Extender robotic cannot
locate its home position within
the lower Library.
Sensor lower home not found.02
Using diagnostic tools and troubleshooting50