HP StorageWorks MSL Library Extender user guide (AQ746-96005, September 2009)
Table Of Contents
- HP StorageWorks MSL Library Extender user guide
- Table of Contents
- 1 Features and overview
- 2 Configuring and operating an extended library
- 3 Installing the Library Extender
- Identifying product components
- Downloading product documentation
- Determining the master and lower Library
- Saving the Library configurations
- Upgrading the Library firmware
- Enabling extended mode
- Removing the cartridges from the Libraries
- Powering off the Libraries
- Positioning the Libraries in a rack
- Relocating tape drives
- Removing and replacing drive bay covers
- Removing the USB device and Ethernet cable from the lower Library
- Extending the pull-out tab
- Aligning the Libraries
- Installing the Extender
- Powering on the extended library
- Verifying the installation
- 4 Using diagnostic tools and troubleshooting
- 5 Servicing the Library Extender
- Replacing the Library Extender
- Removing the Library Extender
- Removing a cartridge from the Extender
- Repackaging the Library Extender
- Releasing the magazines manually
- 6 Support and other resources
- A Technical specifications
- B Electrostatic discharge
- C Regulatory compliance notices
- Glossary
- Index
SolutionCauseMessageSub-code
• Power cycle the master
Library and run the Library
Extender cycle test.
• Retry the operation. If the
motor is still blocked, re-
move the Extender from the
Libraries, and then inspect
the Extender and master
Library for a physical
blockage. Re-install the Ex-
tender.
The Extender robotic is stuck
in its home position within the
master Library.
Motor blocked in master home
position.
03
• Power cycle the lower Lib-
rary and run the Library
Extender cycle test.
• Retry the operation. If the
motor is still blocked, re-
move the Extender from the
Libraries, and then inspect
the Extender and lower
Library for a physical
blockage. Re-install the Ex-
tender.
• Retry the operation.
The Extender robotic is stuck
in its home position within the
lower Library.
Motor blocked in lower home
position.
04
• Power cycle both Libraries
and run the Library Ex-
tender cycle test.
• Retry the operation. If the
motor is still blocked, re-
move the Extender from the
Libraries, and inspect the
Extender and master Lib-
rary for a physical block-
age. Re-install the Extender.
• Retry the operation.
The Extender robotic is stuck
between its two home posi-
tions.
Motor blocked between master
and lower home position.
05
• Power cycle the both Librar-
ies and run the Library Ex-
tender cycle test.
• Retry the operation. If the
motor is still blocked, re-
move the Extender from the
Libraries, and then inspect
the Extender and master
Library for a physical
blockage. Re-install the Ex-
tender.
The Extender robotic is stuck
and the motor is hot.
Motor blocked and hot.06
HP StorageWorks MSL Library Extender user guide 51