HP StorageWorks MSL Library Extender user guide (AQ746-96005, September 2009)
Table Of Contents
- HP StorageWorks MSL Library Extender user guide
- Table of Contents
- 1 Features and overview
- 2 Configuring and operating an extended library
- 3 Installing the Library Extender
- Identifying product components
- Downloading product documentation
- Determining the master and lower Library
- Saving the Library configurations
- Upgrading the Library firmware
- Enabling extended mode
- Removing the cartridges from the Libraries
- Powering off the Libraries
- Positioning the Libraries in a rack
- Relocating tape drives
- Removing and replacing drive bay covers
- Removing the USB device and Ethernet cable from the lower Library
- Extending the pull-out tab
- Aligning the Libraries
- Installing the Extender
- Powering on the extended library
- Verifying the installation
- 4 Using diagnostic tools and troubleshooting
- 5 Servicing the Library Extender
- Replacing the Library Extender
- Removing the Library Extender
- Removing a cartridge from the Extender
- Repackaging the Library Extender
- Releasing the magazines manually
- 6 Support and other resources
- A Technical specifications
- B Electrostatic discharge
- C Regulatory compliance notices
- Glossary
- Index
MessageSub-code
Error during elevator movement to extender positionF5
Error during sled movement to rotate positionF6
Error during rotational movementF7
Error cartridge present sensor during cartridge transfer from robotics to extender
carrier (and reverse)
F8
Cartridge present sensor deviates from expected parameterF9
Error during first slider movement (movement with opened gripper) from/to extender
position
FA
Error during first gripper movement (open gripper) from/to extender positionFB
Error during second gripper movement (close gripper) from/to extender positionFC
Error during third slider movement (move to block) from/to extender positionFD
Error during third gripper movement (close gripper) from extender positionFE
Error during fourth slider movement (pull back) from/to extender positionFF
Using diagnostic tools and troubleshooting54