HP B-series 16Gb FC Switches Hardware Reference Guide

Table 7 SAN Switch Rack Mount Kit hardware
DescriptionItem
Two rear mounting brackets
A right inner rail and a right outer
rail
A left inner rail and a left outer rail
14 #8-32 x 5/16-inch Phillips
panhead SEMS screws for use with
the HP StoreFabric SN6500B 16Gb
FC Switch. This switch requires 10
screws.
14 #8-32 x 3/16-inch Phillips
panhead screws with thread lock
(do not use)
Ten #10-32 x 1/2-inch Phillips
panhead screws with captive star
lock washers
Eight #10 alignment washers
Eight #10 adapter washers
Two 1/4-20 hex nuts with captive
star lock washers
Two 1/4-inch flat washers
CAUTION: For proper airflow, the SFP+ media side of the switch port-side must face the rear of
the rack. This allows cool air to enter the front of the rack and exit from the rear.
For switches with Port Side Air Intake, the SFP+ media side of the switch port side must face the
front of the rack.
To install the switch in a rack:
1. Verify that the required parts and hardware are available. See Table 7 (page 24).
2. Choose a mounting location for the switch in the rack.
3. Attach the rear mounting brackets to the rear rack uprights.
24 Installing and configuring HP 16Gb FC switches