HP B-series 16Gb FC Switches Hardware Reference Guide

NOTE: For switches with Port Side Air Intake, attach the rear mounting brackets to the front
rack uprights.
• For an HP 10000 Series Rack, assemble each of the brackets using two #10-32 x 1/2-inch
Phillips panhead screws with captive star lock washers and two #10 adapter washers,
as shown in Figure 9 (page 25).
• For an HP System/e Rack, install the two rear mounting brackets using two 8-32 x
5/16-inch Phillips panhead SEMS screws and two #10 alignment washers, as shown in
Figure 10 (page 25).
Figure 9 Installing the rear mounting brackets (HP 10000 Series Rack)
Figure 10 Installing the rear mounting brackets (HP System/e Rack)
Installing the switch 25