HP B-series 16Gb FC Switches Hardware Reference Guide

Table 11 Switch management tools
In-band supportOut-of-band supportManagement tool
IP over FCEthernet or serial connectionCLI
Up to two admin sessions and four user sessions
simultaneously. See the Fabric OS Administrator’s Guide
and the Fabric OS 7.0.x Command Reference Manual.
IP over FCEthernet or serial connectionWeb Tools
See the Web Tools Administrator’s Guide.
IP over FCEthernet or serial connectionStandard SNMP applications
See the MIB Reference Manual.
Native in-band interface
(over HBA only)
Ethernet or serial connectionManagement Server
See the Fabric OS Administrator’s Guide and the Fabric
OS 7.0.x Command Reference Manual.
IP over FCEthernet or serial connectionNetwork Advisor (option to purchase)
See the Network Advisor documentation set.
FRU removal and replacement
No special tools are required to remove and replace the power supply and fan assembly FRU (HP
StoreFabric SN6500B 16Gb FC Switch, HP SN6000B 16Gb FC Switch and HP SN3000B 16Gb
FC Switch). The switches will continue to operate during the FRU replacement if you follow the
procedures in this chapter. However, the HP SN3000B 16Gb FC Switch will continue to operate
normally only if it has two power supplies installed. The HP SN3000B 16Gb FC switch comes
with only one power supply by default and if removed will have no power. Replacing a power
supply and fan assembly takes less than two minutes.
CAUTION: Disassembling any part of the power supply voids the part warranty and regulatory
certifications. There are no user-serviceable parts inside the power supply and fan assembly. The
cooling system relies on pressurized air, so do not leave either of the power supply and fan assembly
slots empty longer than two minutes when the switch is operating. If a power supply and fan
assembly fails, leave the power supply and fan assembly in the switch until it can be replaced.
The power supply and fan assembly must be operational to ensure redundancy.
Replacing an HP StoreFabric SN6500B 16Gb FC Switch power supply
The HP StoreFabric SN6500B 16Gb FC Switch has two power supplies, as shown in
Figure 31 (page 55). The Fabric OS identifies the power supplies from left to right on the nonport
side as power supply #2 and power supply #1.
See this cautionary note before beginning replacement “CAUTION”
See Table 8 (page 48) for the power supply status LED colors, patterns, and recommended actions,
if any.
FRU removal and replacement 53