Brocade Fabric OS v7.0.2e Release Notes v1.0

Fabric OS v7.0.2e Release Notes v1.0 Page 42 of 53
Defect ID:
DEFECT000480765
Technical Severity:
Medium
Probability:
Medium
Product:
FOS
Technology:
Management
Reported In Release:
FOS7.2.0
Technology Area:
Web Tools
Symptom:
“Application Blocked by Security Settings” is displayed and fails to launch EZ Manager
Condition:
This issue will be seen only with older JRE updates (40 and below).
Workaround:
Use latest JRE
Defect ID:
DEFECT000481199
Technical Severity:
Medium
Probability:
Medium
Product:
FOS
Technology:
Management
Reported In Release:
FOS7.2.0
Technology Area:
Web Tools
Symptom:
With JRE 1.7.0 update 45, users will see a warning message when WebTools is launched through
HTTPS and will not be able to launch WebTools from Brocade Network Advisor versions prior to
v12.1.4.
Condition:
Web Tools will be blocked when it is launched through a version of Brocade Network Advisor prior
to 12.1.4 on a system running JRE 1.7u45.
Web Tools will encounter error messages when it is launched directly through HTTPs on a system
running JRE 1.7u45.
Workaround:
Launch Web Tools through Brocade Network Advisor running version 12.1.4 or higher.
Recovery:
JRE must be downgraded to 1.7u25.
Defect ID:
DEFECT000484414
Technical Severity:
High
Probability:
Medium
Product:
FOS
Technology:
Virtualization
Reported In Release:
FOS7.0.2
Technology Area:
Access Gateway
Symptom:
Under rare conditions, Access Gateway(AG) entries stay in management server (MS) database even
after removing them from the fabric.
FOS firmware is expected to remove these stale entries during execution of agshow CLI command.
However, due to a timing issue the stale entries may not be removed from the database when agshow
CLI command is run.
Condition:
This may be observed on a switch running firmware version higher than v7.0.
Defect ID:
DEFECT000485708
Technical Severity:
High
Probability:
Medium
Product:
FOS
Technology:
Virtualization
Reported In Release:
FOS6.4.3_dcb
Technology Area:
NPIV
Symptom:
3rd party application fails when connected to a BR8470 FCoE switch running FOS v6.4.3_dcb in
Access Gateway mode. Device re-FDISC on one of its logins is incorrectly rejected by the Access
Gateway.
Condition:
This issue occurs under the following conditions:
1. Switch is in Access Gateway mode
2. Device has already logged into a NPIV port on Access Gateway
3. NPIV device has also already logged in (with FDISC) to the same port
4. NPIV device logs in again (with FDISC) on the same port
Recovery:
Bounce (offline, then online) the Access Gateway port.