Brocade Fabric OS Command Reference v7.1.0 (53-1002746-01, March 2013)

190 Fabric OS Command Reference
53-1002746-01
cryptoCfg
2
-rx
Displays receiver throughput.
-tx -rx
Displays transmitter and receiver throughput.
-t interval
Specifies the time interval,in seconds, between refreshes.
EXAMPLES To create an encryption group "brocade":
SecurityAdmin:switch> cryptocfg --create -encgroup brocade
Encryption group create status: Operation Succeeded.
To create an encryption group "brocade" on a node that has stale configurations:
SecurityAdmin:switch> cryptocfg --create -encgroup brocade
Warning: There are stale (Container|HA|Tape) cryptodb configurations.
Please confirm to delete them.
ARE YOU SURE (yes, y, no, n): [no] y
Warning: These are the list of crypto configuration \
to be cleaned up:
Inside /etc/fabos/mace (crypto_dek.db.0, crypto_dev.db.0, \
crypto_hac.db.0, crypto_pool.db.0, crypto_wwn.db.0).
ARE YOU SURE (yes, y, no, n): [yes]y
Encryption group create status: Operation Succeeded.
To delete the encryption group "brocade":
SecurityAdmin:switch> cryptocfg --delete -encgroup brocade
Encryption group create status: Operation Succeeded.
To register a NetApp LKM appliance as the primary key vault "LKM1":
SecurityAdmin:switch> cryptocfg --reg -regkeyvault \
LKM1 lkmcert.pem 10.33.54.231 primary decru-lkm-1
Register key vault status: Operation Succeeded.
To set the key vault type to LKM:
SecurityAdmin:switch> cryptocfg --set -keyvault LKM
Set key vault status: Operation Succeeded.
To add a member node to the encryption group:
SecurityAdmin:switch> cryptocfg --add -membernode \
10:00:00:05:1e:39:14:00
Add node status: Operation Succeeded.
To eject a member node from the encryption group:
SecurityAdmin:switch> cryptocfg --eject -membernode \
10:00:00:05:1e:53:b8:45
Eject node status: Operation Succeeded.
To leave the encryption group:
SecurityAdmin:switch> cryptocfg --leave_encryption_group
Leave node status: Operation Succeeded.