Cisco Nexus 5000 Series Switch Fabric Manager Software Configuration Guide, NX-OS 4.0 (OL-16598-01, June 2008)

Send comments to [e-mail]
9-3
Nexus 5000 Series Switch Fabric Manager Software Configuration Guide
OL-16598-01
Chapter 9 Configuring Virtual Interfaces
Configuring Virtual Interfaces
Figure 9-2 Create VIG Dialog Box
Step 3 Choose a switch in the Switch pull-down menu.
Step 4 Enter the Virtual Interface Group number in the Id field.
Step 5 (Optional) Select a physical Ethernet interface to bind to the Virtual Interface Group.
The newly created virtual interface group is displayed in the Virtual Interface Groups table. In the Create
Virtual Interface Group dialog box, the Id field increments by 1.
Step 6 (Optional) Repeat steps 3 through 6 to create additional virtual interface groups.
Step 7 Click Close to finish.
Using the Virtual Interface Group Wizard
To create a virtual interface group using the Virtual Interface Group wizard, perform this task:
Step 1 Click the Virtual Interface Group button on the tool bar.
You see the Virtual Interface Group wizard dialog box as shown in Figure 9-3.