Cisco Nexus 5000 Series Switch Fabric Manager Software Configuration Guide, NX-OS 4.0 (OL-16598-01, June 2008)

Send comments to [e-mail]
9-4
Nexus 5000 Series Switch Fabric Manager Software Configuration Guide
OL-16598-01
Chapter 9 Configuring Virtual Interfaces
Configuring Virtual Interfaces
Figure 9-3 Virtual Interface Group Wizard
Step 2 Follow the directions in the Virtual Interface Group Wizard. Choose the switch where the Virtual
Interface Group will be created, the physical Ethernet port associated with the Virtual Interface Group,
and the Virtual Interface Group ID.
Step 3 Click Finish to commit and distribute the change.
Binding a VIG to a Physical Ethernet Interface
To bind the VIG to a physical Ethernet port, perform this task:
Step 1 In the Physical Attributes pane, expand Switches > Interfaces > Ethernet > FCoE, and then choose
Virtual Interface Groups.
You see the Virtual Interface Groups in the information pane as shown in Figure 9-1.
Step 2 Click the Bound Eth Interface entry for the Virtual Interface Group that needs to be modified. Enter
the physical interface.
Step 3 Click Apply Changes to commit and distribute the change.
Deleting a Virtual Interface Group
To delete a VIG, perform this task:
Step 1 In the Physical Attributes pane, expand Switches > Interfaces > Ethernet > FCoE, and then choose
Virtual Interface Groups.