Cisco Nexus 5000 Series Switch Fabric Manager Software Configuration Guide, NX-OS 4.0 (OL-16598-01, June 2008)

Send comments to [e-mail]
11-5
Nexus 5000 Series Switch Fabric Manager Software Configuration Guide
OL-16598-01
Chapter 11 Configuring Domain Parameters
Information About Fibre Channel Domains
Figure 11-4 Running Domain Configuration
Step 2
Click the Configuration tab.
You see the switch configuration as shown in Figure 11-3.
Step 3 Set Priority to a high value for the switch in the fabric that you want to be the principal switch.
Step 4 Click the Apply Changes icon to save these changes.
About fcdomain Initiation
By default, the fcdomain feature is enabled on each switch. If you disable the fcdomain feature in a
switch, that switch can no longer participate with other switches in the fabric. The fcdomain
configuration is applied to runtime through a disruptive restart.
Enabling or Disabling fcdomains
To disable fcdomains in a single VSAN or a range of VSANs using Fabric Manager, perform this task:
Step 1 Expand Fabricxx > VSANxx, and then choose Domain Manager in the Logical Domains pane for the
fabric and VSAN that you want to disable fcdomain for.
You see the domain’s running configuration in the Information pane.
Step 2 Click the Configuration tab and uncheck the Enable check box (see Figure 11-5) for each switch in the
fabric that you want to disable fcdomain on.