Cisco Nexus 5000 Series Switch Fabric Manager Software Configuration Guide, NX-OS 4.0 (OL-16598-01, June 2008)

Send comments to [e-mail]
11-6
Nexus 5000 Series Switch Fabric Manager Software Configuration Guide
OL-16598-01
Chapter 11 Configuring Domain Parameters
Information About Fibre Channel Domains
Figure 11-5 Configuring Domains
Step 3
Click the Apply Changes icon to save these changes.
Setting Fabric Names
To set the fabric name value for a disabled fcdomain using Fabric Manager, perform this task:
Step 1 Expand Fabricxx > VSANxx, and then choose Domain Manager in the Logical Domains pane for the
fabric and VSAN that you want to set the fabric name for.
You see the running configuration of the domain in the Information pane.
Step 2 Click the Configuration tab and set the fabric name for each switch in the fabric.
Step 3 Click the Apply Changes icon to save these changes.
About Incoming RCFs
You can choose to reject RCF request frames on a per-interface, per-VSAN basis. By default, the RCF
reject option is disabled (that is, RCF request frames are not automatically rejected).
The RCF reject option takes effect immediately.
No fcdomain restart (see the “About Domain Restart” section on page 11-3).
Note You do not need to configure the RFC reject option on virtual Fibre Channel interfaces, because these
interfaces operate only in F port mode.
Rejecting Incoming RCFs
To reject incoming RCF request frames using Fabric Manager, perform this task:
Step 1 In the Physical Attributes pane, expand Switches > Interfaces, and then choose FC Physical.
You see the Fibre Channel configuration in the Information pane.