Cisco Nexus 5000 Series Switch Fabric Manager Software Configuration Guide, NX-OS 4.0 (OL-16598-01, June 2008)

Send comments to [e-mail]
13-4
Nexus 5000 Series Switch Fabric Manager Software Configuration Guide
OL-16598-01
Chapter 13 Configuring VSAN Trunking
Configuring VSAN Trunking
Configuring Trunk Mode
To configure trunk mode using Fabric Manager, perform this task:
Step 1 In the Physical Attributes pane, expand Switches > Interfaces, and then choose FC Physical.
You see the interface configuration in the Information pane.
Step 2 Click the Trunk Config tab to modify the trunking mode for the selected interface.
You see the information shown in Figure 13-4.
Figure 13-4 Trunking Configuration
Step 3 Make changes to the Admin and Allowed VSANs values.
Step 4 Click the Trunk Failures tab to check the failure state of an ISL.
You see the reason listed in the FailureCause column (see Figure 13-5).
Figure 13-5 Trunk Failures Tab
Step 5
Click the Apply Changes icon.