Cisco Nexus 5000 Series Switch Fabric Manager Software Configuration Guide, NX-OS 4.0 (OL-16598-01, June 2008)

Send comments to [e-mail]
13-6
Nexus 5000 Series Switch Fabric Manager Software Configuration Guide
OL-16598-01
Chapter 13 Configuring VSAN Trunking
Configuring VSAN Trunking
Figure 13-7 Operational and Allowed VSAN Configuration
Configuring an Allowed-Active List of VSANs
To configure an allowed-active list of VSANs for an interface using Fabric Manager, perform this task:
Step 1 In the Physical Attributes pane, expand Interfaces, and then choose FC Physical.
You see the interface configuration in the Information pane.
Step 2 Click the Trunk Config tab.
You see the current trunk configuration.
Step 3 Set Allowed VSANs to the list of allowed VSANs for each interface that you want to configure.
Step 4 Click Apply Changes to save these changes or click Undo Changes to discard any unsaved changes.
V
SANs 1 and 3 are on th
e
allowed
l
ist
.
V
SA
Ns 1 and 3 are operatio
nal
.
V
SA
Ns
1
, 2, 5 are o
p
era
tion
al
.
V
SA
Ns
1,
2, 5 are o
n
the all
o
we
d
list.
VSANs 1 and 2 are operational.
VSANs 1 and 2 are on the allowed list.
Switch 3
VSAN1
VSAN2
VSAN4
VSAN5
Switch 1
VSAN1
VSAN2
VSAN3
VSAN4
VSAN5
Switch 2
VSAN1
VSAN2
VSAN3
79946