Cisco Nexus 5000 Series Switch Fabric Manager Software Configuration Guide, NX-OS 4.0 (OL-16598-01, June 2008)

Send comments to [e-mail]
18-4
Nexus 5000 Series Switch Fabric Manager Software Configuration Guide
OL-16598-01
Chapter 18 Configuring Fibre Channel Routing Services and Protocols
FSPF Global Configuration
Table 18-1 displays the default settings for switch responses.
The LSR minimum arrival time is the period between receiving LSR updates on this VSAN. Any LSR
updates that arrive before the LSR minimum arrival time are discarded.
The LSR minimum interval time is the frequency at which this switch sends LSR updates on a VSAN.
Configuring FSPF on a VSAN
To configure an FSPF feature for the entire VSAN using Fabric Manager, perform this task:
Step 1 Expand a Fabric, expand a VSAN, and then choose FSPF for a VSAN that you want to configure for
FSPF.
You see the FSPF configuration in the Information pane as shown in Figure 18-3.
Figure 18-3 FSPF General Information
You can enter values for RegionID, Spf Comp Holdtime, LSR Min Arrival, and LSR Min Interval. These
values apply to all interfaces on the VSAN.
Step 2 Click Apply Changes to save these changes, or click Undo Changes to discard any unsaved changes.
Table 18-1 LSR Default Settings
LSR Option Default Description
Acknowledgment
interval (RxmtInterval)
5 seconds The time a switch waits for an acknowledgment from the LSR
before retransmission.
Refresh time
(LSRefreshTime)
30 minutes The time a switch waits before sending an LSR refresh
transmission.
Maximum age (MaxAge) 60 minutes The time a switch waits before dropping the LSR from the
database.