Cisco Nexus 5000 Series Switch Fabric Manager Software Configuration Guide, NX-OS 4.0 (OL-16598-01, June 2008)

Send comments to [e-mail]
20-4
Nexus 5000 Series Switch Fabric Manager Software Configuration Guide
OL-16598-01
Chapter 20 Configuring SPAN
Configuring SPAN
Figure 20-1 Create SPAN Sessions Dialog Box
Step 4
Choose the session ID (from 1-16) using the up or down arrows and click Create.
Step 5 Repeat Step 4 for each session that you want to create.
Step 6 Enter the destination interface in the Dest Interface field for the appropriate session.
Step 7 Enter the filter VSAN list in the Filter VSAN List field for the appropriate session.
Step 8 Choose active or in active admin status in the Admin drop-down list.
Step 9 Click Apply to save your changes.
Step 10 Close the two dialog boxes.
Editing SPAN Sources Using Device Manager
To edit a SPAN source using Device Manager, perform this task:
Step 1 Choose Interface > SPAN.
You see the SPAN dialog box.
Step 2 Click the Sources tab.
You see the SPAN Sources dialog box as shown in Figure 20-2.
Figure 20-2 SPAN Sources Tab
Step 3 Enter the VSAN list name in the VSAN List field.
Step 4 Click Edit Interface List.
You see the Source Interfaces dialog box.
Step 5 Click Create.