Cisco Nexus 5000 Series Switch Fabric Manager Software Configuration Guide, NX-OS 4.0 (OL-16598-01, June 2008)

Send comments to [e-mail]
20-5
Nexus 5000 Series Switch Fabric Manager Software Configuration Guide
OL-16598-01
Chapter 20 Configuring SPAN
Default SPAN Settings
You see the Source Interfaces Interface Sources dialog box as shown in Figure 20-3.
Figure 20-3 Source Interfaces Interface Sources Dialog Box
Step 6
Click the browse button to display the list of available FC ports.
Step 7 Choose a port and click OK.
Step 8 Check the direction (receive or transmit) that you want.
Step 9 Click Create to create the FC interface source.
Step 10 Click Close in each of the three open dialog boxes.
Deleting SPAN Sessions Using Device Manager
To delete a SPAN session using Device Manager, perform this task:
Step 1 Choose Interface > SPAN.
You see the SPAN dialog box.
Step 2 Click the Sessions tab.
Step 3 Click the SPAN session that you want to delete.
Step 4 Click Delete.
The SPAN session is deleted.
Step 5 Close the dialog box.
Default SPAN Settings
Table 20-1 lists the default settings for SPAN parameters.
Table 20-1 Default SPAN Configuration Parameters
Parameters Default
SPAN session Active.
If filters are not specified SPAN traffic includes traffic through a specific interface from all active
VSANs.