Cisco Nexus 5000 Series Switch Fabric Manager Software Configuration Guide, NX-OS 4.0 (OL-16598-01, June 2008)

Send comments to [e-mail]
31-11
Nexus 5000 Series Switch Fabric Manager Software Configuration Guide
OL-16598-01
Chapter 31 Troubleshooting Your Fabric
Running CLI Commands
Running CLI Commands
You can use the Run CLI Commands feature to run a CLI command on multiple switches. To run CLI
commands using Fabric Manager, perform this task:
Step 1 Choose Tools > Run CLI Commands.
You see the Run CLI Commands dialog box with all switches selected as shown in Figure 31-8.
Figure 31-8 Run CLI Commands Dialog Box
Step 2
Uncheck the check box for the switch(es) for which you do not want to run CLI commands.
Step 3 Specify where you want the file to be saved.
Note A separate report is issued for each switch. Check the reports to verify whether a CLI command
failed.
Step 4 Enter the command(s) in the Command(s) text box. If the commands are configuration mode commands,
you must also enter the exit command.
Note For the commands to execute, you cannot be in configuration mode.
Step 5 Click OK to run the CLI command(s).
You see the Run CLI Commands dialog box showing the status of each switch as shown in Figure 31-9.