Cisco Nexus 5000 Series Switch Fabric Manager Software Configuration Guide, NX-OS 4.0 (OL-16598-01, June 2008)

Send comments to [e-mail]
31-12
Nexus 5000 Series Switch Fabric Manager Software Configuration Guide
OL-16598-01
Chapter 31 Troubleshooting Your Fabric
Locating Other Switches
Figure 31-9 Run CLI Commands Status
Step 6
Click Close to close the dialog box.
Adjusting for Daylight Savings Time
Note Starting in 2007, daylight savings time in the United States starts on the second Sunday in March and
ends on the first Sunday in November.
You can use the Run CLI Commands feature in Fabric Manager to adjust the time change configuration
in your switches. Enter the following commands in the Command(s) text box:
configure
no clock summer-time
clock summer-time daylight_timezone_name 2 Sunday March 02:00 1 Sunday November 02:00 60
Locating Other Switches
The Locate Switches option uses SNMPv2 and discovers devices responding to SNMP requests with the
read-only community string public. You can use this feature in these situations:
• You have third-party switches that do not implement the FC-GS3 FCS standard that provides
management IP addresses.
• You want to locate other Cisco switches in the subnet but are not physically connected to the fabric.