Cisco Nexus 5000 Series Switch Fabric Manager Software Configuration Guide, NX-OS 4.0 (OL-16598-01, June 2008)

Send comments to [e-mail]
2-16
Nexus 5000 Series Switch Fabric Manager Software Configuration Guide
OL-16598-01
Chapter 2 Installing Cisco Fabric Manager
Installing the Management Software
Installing Device Manager
The Device Manager software executable file resides on the switch supervisor module. To install or
upgrade the Device Manager software, access the supervisor module with a web browser and click the
Install link on the web page that is displayed. The software running on your workstation is verified to
make sure you are running the most current version of Device Manager. If it is not current, the most
recent version is downloaded and installed on your workstation.
To install Device Manager on your workstation, perform this task:
Step 1 Enter the IP address of the switch in the Address field of your browser.
You see the Installation window for Device Manager as shown in Figure 2-10.
Figure 2-10 Device Manager Installation Window
Step 2 Click the Cisco Device Manager link.
You see the welcome to the management software setup wizard message in the Cisco Device Manager
Installer window as shown in Figure 2-11.