Cisco Nexus 5000 Series Switch Fabric Manager Software Configuration Guide, NX-OS 4.0 (OL-16598-01, June 2008)

Send comments to [e-mail]
2-18
Nexus 5000 Series Switch Fabric Manager Software Configuration Guide
OL-16598-01
Chapter 2 Installing Cisco Fabric Manager
Upgrading the Management Software
Once the installation is finished, you see an installation completed message in the Cisco Device Manager
Installer window as shown in Figure 2-13.
Figure 2-13 Installation Complete
Step 7
Click Finish to close the Cisco Device Manager Installer window.
Upgrading the Management Software
If you log into a switch with Device Manager and that switch has a later version of the Device Manager
software, you are prompted to install the later version. You can also upgrade Device Manager at any time
by entering the IP address or host name of the supervisor module with the later version of software in
the Address field of your browser.
Note Downgrades are not supported through the installer. To downgrade Device Manager to an earlier release,
you need to manually uninstall first, and then reinstall the previous version of Device Manager.
To upgrade the Cisco Fabric Manager software, follow the instructions described in the “Installing the
Management Software” section on page 2-5. The installer supports software upgrade of the Fabric
Manager application.
Integrating Cisco Fabric Manager with Other Management
Tools
You can use Fabric Manager, Device Manager, and Performance Manager with these management tools:
• Cisco Traffic Analyzer—Allows you to break down traffic by VSANs and protocols and to examine
SCSI traffic at a logical unit number (LUN) level.