Brocade Fabric OS Command Reference Manual (53-1000240-01, November 2006)

Fabric OS Command Reference Manual 2-375
Publication Number: 53-1000240-01
nsZoneMember
2
Note: Enter commands in lowercase only; mixed case is for readability.
nsZoneMember
Displays the information of all the online devices zoned with the given device.
Synopsis nszonemember -a | -u | pid | wwn
Description Use this command to display information about all the online devices zoned with the given device.
Issuing this command without operands displays all online devices zoned with the given device. Each
line of output displays:
Type U for unknown, N for N_Port, NL for NL_Port
Pid The 24-bit Fibre Channel address
COS A list of classes of service supported by the device
PortName The device's port World Wide Name (WWN)
NodeName The device's node WWN
Permanent Port Name Physical N_Port or NL_Port WWN
DeviceType The device’s type
Port Index The port index this device is attached to
Shared Area Whether this device shares an area with other devices
Device Shared in Other ADWhether device is shared in other Admin Domains
There might be additional lines if the device has registered any of the following information (the switch
automatically registers SCSI inquiry data for FCP target devices):
• FC4 supported
• IP address (node)
•IPA
• port and node symbolic name (local device only)
• fabric port name
• hard address and/or port IP address
Operands This command has the following operands:
-a Displays each local device’s online zoned device data, including the PID and zone
alias.
-u Displays all the unzoned devices in the entire fabric. The device data displayed
includes the device PID and zone alias.
pid | wwn Specifies the port ID or WWN, respectively, whose zoned devices are to be
viewed. This operand is required.