Brocade Fabric OS Command Reference Manual (53-1000240-01, November 2006)

2-438 Fabric OS Command Reference Manual
Publication Number: 53-1000240-01
portCfg
2
Note: Enter commands in lowercase only; mixed case is for readability.
Specifies the maximum retransmissions for the existing tunnel.
retransmissions values are 1 to 16; default is 8. If tape
pipelining is enabled, default value is calculated based on the
mininum retransmit time to ensure that tcp connection does not
timeout before the host times out. If the user changes this value,
the value specified must be greater than the calculated value.
-s 0|1
Disable (0) or Enable (1) selective acknowledgement
(SACK) on the existing tunnel.
-t 0|1
Disable (0) or Enable (1) tape pipelining on turned on as well).
• delete tunnel_id
Deletes FCIP tunnels.
ipif IP interface entries. Usage: portcfg ipif [slot/][ge]port args. Valid args for ipif
are:
• create ipaddr netmask mtu_size
Creates IP interfaces.
• delete ipaddr
Deletes IP interfaces.
iproute IP route entries. Usage: portcfg iproute [slot/][ge]port args. Valid args for
iproute are:
• create ipaddr netmask gateway_router metric
Creates IP routes.
• delete ipaddr netmask
Deletes IP routes.
rscnsupr Manages RSCN suppression on the local port. Usage: portcfg rscnsupr [slot/
][ge]port args. Valid args for iproute are:
• -range
Specifies a range of ports in the same slot to apply the configuration to.
• --disable
Disables the configuration. When disabled, device changes on the port
generates RSCN to another end device that is zoned with this one. By default,
RSCN suppression is disabled to all ports.
• --enable
Enables the configuration. When enabled, any device change on the port does
not generate RSCN to any other end device.
Operands This command has the following operands:
slot For bladed systems only, specifies the slot number of the port to be configured,
followed by a slash (/).
port Specifies the number of the ports to be configured, relative to its slot for bladed
systems. For GbE ports, the ports are numbered ge0 and ge1. Use switchShow for
a list of valid ports.
ipaddr Specifies the interface protocol as IP and the IP address on the GbE port. Use this