Brocade Fabric OS Command Reference Manual (53-1000240-01, November 2006)

Fabric OS Command Reference Manual 2-477
Publication Number: 53-1000240-01
portLedTest
2
Note: Enter commands in lowercase only; mixed case is for readability.
portLedTest
Cycles user port LEDs.
Synopsis portledtest [-npass count][-ports itemlist]
Description Use this command to exercise the user port LEDs in the current switch on and off by setting the ATTN
LEDs to green for the ON condition and unlighted for the OFF condition. The SPEED LEDs are initially
set to black before the command execution. The SPEED LEDs are set to green once the command is
executing.
You must disable the current switch (using the switchDisable command) before running this command.
After the command had completed, the ATTN LEDs flash amber, indicating that the command has
finished and exited. You can enable the current switch (using the switchEnable command) to set the
ATTN LEDs back to black.
N
ote
The execution of this command is subject to Admin Domain restrictions that may be in place.
Operands This command has the following operands:
-npass count Specify the number of times to perform this test. The default value is 10.
-ports itemlist Specify a list of user ports to run the test. If omitted, all the active ports in the
switch are assumed. For more information, refer to the itemList command.
Examples To test port LEDs:
See Also itemList, switchDisable, switchEnable
switch:admin> portledtest -ports 1/1-1/5
passed.