Brocade Fabric OS Command Reference Manual (53-1000240-01, November 2006)

Fabric OS Command Reference Manual 2-19

Publication Number: 53-1000240-01

agtCfgSet

Note: Enter commands in lowercase only; mixed case is for readability.

agtCfgSet

Modifies the SNMP agent configuration.

Synopsis agtcfgset

Description Use this command to modify the configuration of the SNMP agent in the switch.

All values successfully configured by this command take effect immediately. These values are persistent

across power cycles and reboots. For dual-domain systems, this command operates on the SNMP agent

associated with the current switch.

This command updates the following values:

sysDescr The system (switch) description. The default value is “Fibre Channel Switch” on

most platforms; however, the default system description value is platform

specific. Different values might appear as the default for some specialized

platforms.

sysLocation The location of the system. The default value is “End User Premise”.

sysContact The contact information for the system. The default value is “Field Support”.

Refer to the Fabric OS MIB Reference Manual for detailed sysDescr, sysLocation,

and sysContact descriptions.

authTrapsEnabled When enabled, the authentication trap, authenticationFailure, is transmitted to a

configured trap recipient in the event that the agent received a protocol message

that is not properly authenticated. In the context of SNMPv1 and SNMPv2c, this

means that a request contains a community string that is not known to the agent.

The default value for this parameter is 0 (disabled).

There are six communities, respective trap recipients, and trap recipient severity levels, supported by the

agent. The first three communities are for read-write (rw) access and the last three are for read-only (ro)

access. The default value for the trap recipient of each community is ‘0.0.0.0’. The default values for the

community strings are:

• Community 1: Secret C0de

• Community 2: OrigEquipMfr

• Community 3: private

• Community 4: public

• Community 5: common

• Community 6: FibreChannel

For an SNMP management station to receive a trap generated by the agent, the administrator must

configure a trap recipient to correspond to the IP address of the management station. In addition, the trap

recipient must be able to pass the access control list (ACL) check.

ote

The execution of this command is subject to Admin Domain restrictions that may be in place.

Trap Recipient Severity Level

The trap severity level is associated with each trap recipient IP address. The event trap level is in