Brocade Fabric OS Command Reference Manual (53-1000240-01, November 2006)

2-20 Fabric OS Command Reference Manual

Publication Number: 53-1000240-01

agtCfgSet

Note: Enter commands in lowercase only; mixed case is for readability.

conjunction with the event's severity level. When an event occurs and if its severity level is at or below

the set value, the SNMP event traps (swEventTrap, swFabricWatchTrap, and connUnitEventTrap) are

sent to the trap recipients. By default, this value is set to 0, implying that no such traps are sent. Possible

values are:

• 0 none

• 1 critical

•2error

•3warning

• 4 informational

• 5 debug

Refer to errShow for related information.

The ACL check is as follows: there are six ACLs to restrict SNMP get/set/trap operations to hosts under

a host-subnet-area. Host-subnet-area is defined by comparing nonzero IP octets. For example, an ACL

of 192.168.64.0 enables access by any hosts that start with the specified octets. The connecting host is

enabled to set each host-subnet-area to be read-write or read-only. The highest privilege matched out of

six entries is given to the access. The ACL check is turned off when all six entries contain 0.0.0.0. The

default values of all six entries are 0.0.0.0.

ote

When secure mode is enabled, the access control list feature is incorporated into the WSNMP and

RSNMP security policies. Community strings can be changed on the primary FCS switch only and will

propagate across the fabric.

Operands none