Brocade Fabric OS Command Reference Manual (53-1000240-01, November 2006)

Fabric OS Command Reference Manual 2-625
Publication Number: 53-1000240-01
snmpConfig
2
Note: Enter commands in lowercase only; mixed case is for readability.
HA-TRAP Specifying yes means the SNMP management application can receive HA traps
from the switch. The default value is 'yes'. Users can also turn on or off individual
HA Traps. The individual HA Traps are fruStatusChanged, cpStatusChanged, and
fruHistoryTrap.
systemGroup Configuration Parameters
sysDescr The system description. The default value is set as Fibre Channel Switch.
sysLocation The location of the system (switch). The default value is set as End User Premise.
sysContact The contact information for this system (switch). The default value is set as Field
Support. Refer to the definition of sysDescr, sysLocation and sysContact in
system group of MIB-II.
authTraps When enabled, the authentication trap (authenticationFailure) is transmitted to a
configured trap recipient in the event that the agent received a protocol message
that is not properly authenticated. In the context of SNMPv1 and SNMPv2c, this
means that a request contains a community string that is not known to the agent.
The default value for this parameter is 0 (disabled).
Operands This command supports following operands:
--show Displays the SNMP agent configuration data of the specified category.
--set Sets the SNMP agent configuration data of the specified category. This operand
displays the current settings and then prompts you to change the values for each
parameter.
--default Sets the SNMP agent configuration data for a specified item to the default values.
Generally, these default values might be available in the configuration database.
It sets to factory default settings if the SNMP agent configuration parameters are
not available in the configuration database.
--show, --set, and --default supports the following:
snmpv1 Selects SNMPv1-related configuration parameters. SNMPv1 parameters include
the community string, trap recipient IP address, and trap severity level associated
with each trap recipient IP address.
snmpv3 Selects SNMPv3-related configuration parameters. SNMPv3 parameters include
user name, authentication protocol and password, SNMPv3 trap recipients IP
address, associated user index, and trap severity level.
accessControl Selects access-control-related parameters. accessControl parameters include
access host subnet area and access permission (read-write).
mibCapability Selects configuration parameters related to the SNMP agent’s MIBs and trap
capability parameters. mibCapability parameters include MIBs and traps
supported by the SNMP agent.
systemGroup Selects configuration parameters related to the system group. systemGroup
parameters include sysDescr, sysLocation, sysContact, and authentication failure
trap.