Brocade Fabric OS Command Reference Manual (53-1000240-01, November 2006)

2-666 Fabric OS Command Reference Manual
Publication Number: 53-1000240-01
switchCfgPersistentEnable
2
Note: Enter commands in lowercase only; mixed case is for readability.
switchCfgPersistentEnable
Enables a switch persistently.
Synopsis switchcfgpersistentenable
Description Use this command to persistently enable the switch. All Fibre Channel ports which did not fail power-on
self-test (POST) are enabled, and can come online if connected to a device, or remain offline if
disconnected. The switch might need to be enabled if it was previously disabled to make configuration
changes or to run diagnostics.
If the switch is connected to a fabric, it rejoins the fabric. After this command is issued, the 10 second
fabric stability count down is displayed. If this switch remains the principal switch at the end of the count
down, then it assigns itself a domain ID. If another switch assumes the principal role, then this switch
becomes a subordinate switch, and accepts a domain ID from the principal. Refer to FC-SW for a
complete description of this process.
The enable process can be observed and verified by watching the front panel LEDs change from slow
flashing yellow as each port is enabled. The LEDs change to green for online ports, or can remain black
for disconnected ports, or yellow for ports that do not initialize.
N
ote
The execution of this command is subject to Admin Domain restrictions that may be in place.
Operands none
Examples To configure the switch as persistently enabled:
See Also switchDisable, switchEnable, switchCfgPersistentDisable, switchShow
switch:admin> switchcfgpersistentenable
10 9 8 7 6 5 4 3 2 1
fabric: Principal switch
fabric: Domain 1