Brocade Fabric OS Command Reference Manual (53-1000240-01, November 2006)

Fabric OS Command Reference Manual 2-693
Publication Number: 53-1000240-01
sysShutdown
2
Note: Enter commands in lowercase only; mixed case is for readability.
To perform a system shutdown from the active CP in a dual-CP platform:
For the FR4-18i AP blade, to perform a system shutdown from the active CP:
For the FR4-18i AP blade, to perform a system shutdown from the standby CP:
See Also haDisable, switchShutdown
switch:admin> sysshutdown
This command will shutdown the operating systems on your switch.
You are required to power-cycle the switch in order to restore operation.
Are you sure you want to shutdown the switch [y/n]? y
This is the active Cp
2005/09/13-01:15:13, [FSSM-1003], 414,, WARNING, Silkworm48000, HA State out of sync
HA is disabled
Broadcast message from root (ttyS0) Tue Sep 13 01:15:14 2005...
The system is going down for system halt NOW !!
INIT: Switching to runlevel: 0
INIT: Sending processes the TERM signal
Unmounting all filesystems.
umount2: Device or resource busy
umount: /tmp: device is busy
The system is halted
flushing ide devices: hda
Power down.
ppc440gx System Halted
switch:admin> sysshutdown
This command will shutdown the operating systems on your switch.
You are required to power-cycle the switch in order to restore operation.
Are you sure you want to shutdown the switch [y/n]? y
This is the active Cp
2005/11/16-05:47:20, [FSSM-1003], 5641,, WARNING, Silkworm12000, HA State out of
sync
HA is disabled
Stopping blade 2
Shutting down the blade....
Stopping blade 8
Shutting down the blade....
Broadcast message from root (ttyS0) Wed Nov 16 05:47:20 2005...
The system is going down for system halt NOW !!
INIT: Switching to runlevel: 0
INIT: Sending processes the TERM signal
Unmounting all filesystems.
umount2: Device or resource busy
umount: /tmp: device is busy
The system is halted
flushing ide devices: hda
Power down.
ppc440gx System Halted
switch:admin> sysshutdown
Shut down the whole system is not support from the standby CP
For shut down the whole system
please run the sysshutdown from the active CP