Brocade Fabric OS Command Reference Manual (53-1000240-01, November 2006)

2-706 Fabric OS Command Reference Manual
Publication Number: 53-1000240-01
trunkDebug
2
Note: Enter commands in lowercase only; mixed case is for readability.
trunkDebug
Debugs a trunk link failure.
Synopsis trunkdebug port1 port2
Description Use this command to debug a trunk link failure. This command reports one of the following messages,
based on the trunking properties of the two specified ports:
• Switch does not support trunking
• Trunking license required
• Trunking not supported in switch interop mode
•port port_id is not E_Port
•port port_id trunking disabled
•port port_id speed is not 2G or 4G
•port port_id and port port_id are not in same port group
•port port_id and port port_id connect to different switches
•port port_id and port port_id connect to the switch WWN
•port port_id is not a trunking port due to: E_Port being disabled, or trunking might be disabled at
remote port
•port port_id and port port_id cannot trunk, please check link length to make sure difference is less
than 400 m
N
ote
The execution of this command is subject to Admin Domain restrictions that may be in place.
Operands This command has the following operands:
port1 Specify the area number of port 1. Use the switchShow command to view the area
numbers for a port. This operand is required.
port2 Specify the area number of port 2. Use the switchShow command to view the area
numbers for a port. This operand is required.
Examples To debug a trunk connection:
See Also portCfgTrunkPort, switchCfgTrunk, trunkShow
switch:admin> trunkdebug 43 44
Switch does not support trunking
switch:admin> trunkdebug 62 63
port 62 and 63 are trunked together