Brocade Fabric OS Command Reference Manual (53-1000240-01, November 2006)

Fabric OS Command Reference Manual 2-43
Publication Number: 53-1000240-01
bladeDisable
2
Note: Enter commands in lowercase only; mixed case is for readability.
bladeDisable
Disables all user ports on a blade.
Synopsis bladedisable slotnumber
Description Use this command to disable all user ports on a blade. All ports on the blade are taken offline. If the
switch was connected to a fabric through this blade, the remaining switches reconfigure, and this switch
will configure based on the other blade ports.
The blade must be disabled before making configuration changes or before running many of the
diagnostic tests.
The blade does not need to be disabled before rebooting or powering off.
Observe and verify the disable process by watching the front panel LEDs change to slow flashing yellow
as each port of the blade disables.
N
ote
A blade cannot be disabled or enabled when the switch is disabled or when the blade itself is faulted,
powered off, or running diagnostics.
N
ote
The execution of this command is subject to Admin Domain restrictions that may be in place.
Operands This command has the following operand:
slotnumber Specify the slot number on which the ports are to be disabled.
Examples To disable blade 2 and then verify:
See Also bladeEnable, portDisable, portEnable, switchShow
switch:admin> bladedisable 2
Blade 2 is being disabled...Done
switch:admin> slotshow
Slot Blade Type ID Status
---------------------------------
1 SW BLADE 2 ENABLED
2 SW BLADE 2 ENABLED (User Ports Disabled)
3 SW BLADE 2 ENABLED
4 SW BLADE 2 ENABLED
5 CP BLADE 1 ENABLED
6 CP BLADE 1 ENABLED
7 SW BLADE 2 ENABLED
8 SW BLADE 2 ENABLED
9 SW BLADE 2 ENABLED
10 SW BLADE 2 ENABLED