Brocade Fabric Watch Administrator's Guide v6.1.0 (53-1000601-02, June 2008)

ManualsBrandsHP ManualsStorageHP SN8000B 4-slot Power Pack+ SAN Director Switch

Fabric Watch Administrator’s Guide 39

53-1000601-02

Fabric Watch threshold configuration

Threshold boundary level is setat : Default

DefaultCustom

Unit Percentage(%) Percentage(%)

Time base minuteminute

Low 0 0

High 100 80

BufSize 0 0.

3. Type 3 at the Select choice => prompt to change the threshold boundary level, and then type 2

at the Enter boundary level type = > prompt to specify that this is a custom value, as shown in

the following system output.

1 : change behavior type 11 : change threshold alarm level

2 : change behavior interval 12 : change changed alarm

3 : change threshold boundary level 13 : change belowalarm

4 : change custom unit 14 : change abovealarm

5 : change custom timebase 15 : change inBetween alarm

6 : change custom low 16 : apply threshold alarm changes

7 : change custom high 17 : cancel threshold alarm changes

8 : change custom buffer 18 : return to previous page

9 : apply threshold boundary changes

10 : cancel threshold boundary changes

Select choice => : (1..18) [18]3

1 : Default

2 : custom

Enter boundary level type => : (1..2) [1] 2

Index ThresholdName BehaviorType BehaviorInt

216 eportRXPerf216 Triggered 1

217 eportRXPerf217 Triggered 1

218 eportRXPerf218 Triggered 1

219 eportRXPerf219 Triggered 1

220 eportRXPerf220 Triggered 1

221 eportRXPerf221 Triggered 1

222 eportRXPerf222 Triggered 1

223 eportRXPerf223 Triggered 1

Threshold boundary level is set at : Custom.

4. Type 9 at the Select choice => prompt to apply the custom value.