Brocade Fabric Watch Administrator's Guide v7.1.0 (53-1002752-01, March 2013)

xvi Fabric Watch Administrator’s Guide
53-1002752-01
What’s new in this document
• Chapter 8, “System Monitoring,” describes how to configure system memory and CPU values
using the sysMonitor command. This chapter also lists the switch status policy factors that
affect the health of the switch, describes how to set and view switch status policies, and
details how to configure FRUs.
• Chapter 9, “Fabric Watch Configuration Using Web Tools,”provides information about how to
use Web Tools to configure Fabric Watch settings, an alternative to using the command line
interface.
• Chapter 10, “Fabric Watch Reports,” describes the reports available through Fabric Watch and
the methods of accessing each report.
Supported hardware and software
Although many different software and hardware configurations are tested and supported by
Brocade Communications Systems, Inc. for Fabric OS 7.1.0, documenting all possible
configurations and scenarios is beyond the scope of this document.
Deprecated hardware platform support
The following hardware platforms are not supported in the Fabric OS 7.1.0 release. These platforms
can interoperate with switches running Fabric OS 7.0.0, but cannot load Fabric OS 7.1.0.
• Brocade 4100
• Brocade 4900
• Brocade 5000
• Brocade 7500/7500E
• Brocade 7600
• Brocade 48000
The following blades are not supported in any chassis operating with Fabric OS 7.1.0:
• FA4-18
• FC4-16IP
• FC4-16
• FC4-32
• FC4-48
What’s new in this document
This document contains information that was available at the time the product was released. Any
information that becomes available after the release of this document is captured in the release
notes.