Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

648 Document Title

xx-xxxxxxx-01

Configuring an FCIP tunnel

FIGURE 288 Add FCIP Tunnel dialog box

4. Click Select Switch Two under Switch Two Settings to display discovered extension switches,

and select the switch that you want to connect to switch one.

The switch name and fabric are displayed in the Switch and Fabric fields.

5. Enter a description of the tunnel in the Description field.

NOTE

You cannot assign a Tunnel ID until after at least one circuit is configured. The Add Circuit

dialog returns you to the Add FCIP Tunnel dialog to allow you to select the Tunnel ID.

6. To add a circuit, click Add to the right of the Circuits properties table at the bottom of the dialog

box.

The Add FCIP Circuit dialog is displayed. Continue with “Adding an FCIP circuit”.