Brocade Network Advisor SAN User Manual v11.1x (53-1002167-01, May 2011)

Brocade Network Advisor IP User Manual 695
53-1002168-01
Adding thresholds
22
FIGURE 316 Edit C3 Discard Frames Threshold dialog box
4. Change the name for the threshold in the Name field, if necessary.
5. Select one of the following options:
• Default—Uses device defaults. Go to step 8.
• Custom—Uses your selections. Continue with step 6.
6. Change the number of discarded frames allowed for the threshold in the Threshold field, if
necessary.
7. Change the time period for the threshold from the errors per list, if necessary.
8. Click OK on the Edit C3 Discard Frames Threshold dialog box.
If the threshold has already been assigned to ports, an “Are you sure you want to make the
requested changes to this threshold on “X” ports?” message displays. Click OK to close.
To assign this threshold to fabrics, switches, or switch ports, refer to “Assigning thresholds” on
page 693.
9. Click OK on the Port Fencing dialog box.
Editing an Invalid CRCs threshold
NOTE
This threshold is only available for Fabric OS devices.
To edit an Invalid CRCs threshold, complete the following steps.
1. Select Monitor > Fabric Watch > Port Fencing.
The Port Fencing dialog box displays.
2. Select Invalid CRCs (Fabric OS only) from the Violation Type list.
3. Select the threshold you want to change and click Edit.
The Edit Invalid CRCs Threshold dialog box displays.
FIGURE 317 Edit Invalid CRCs Threshold dialog box