Brocade Web Tools Administrator's Guide v6.0.0 (53-1000606-01, April 2008)

Web Tools Administrator’s Guide 139
53-1000606-01
Configuring FCR router port cost
10
You will need to specify the Fabric ID and, if configuring an FC port, the speed and long
distance mode. You can choose any unique fabric ID as long as it is consistent for all EX_Ports
that connect to the same edge fabric.
Editing the configuration of an EX_Port
1. Opens the FC Routing module.
2. Click the EX_Ports tab.
3. Select a port to configure, by clicking in the row.
4. Click Edit Configuration in the task bar.
This opens the port configuration wizard, which guides you through the port configuration
process.
The current configuration values are displayed in the wizard steps.
If you choose to configure a disabled port, the wizard provides the Enable Port after
configuration check box. If you select this check box, the disabled port is automatically
enabled after configuration. If you leave this box cleared, the port remains in the same state
after configuration.
Configuring FCR router port cost
In FCR, EX_Ports can be assigned router port cost. The cost of the link is a positive number. The
router port path or tunnel path is chosen based on the minimum cost per connection. If multiple
paths exist with the same minimum cost, there will be load sharing over these paths. If multiple
paths exist where one path costs lower than the others, then the lowest cost path is used.
Every link has a default cost. For an EX_Port 2Gb/sec link, the default cost is 500. For an EX_Port
1Gb/sec link, the default cost is 1000. For a VEX_Port, the default cost is 2000. If the cost is set to
0, the default cost will be used for that link.
1. Open the Switch Administration window.
2. Click FCR in Manage section of the Tasks menu.
3. Click the Ex Ports tab.
Viewing and configuring LSAN zones
The LSAN Zones tab displays all the LSAN zones, in both a tabular and tree form. (If FC-FC Routing
is disabled, the tables and tree nodes in this tab are empty.)
For more detailed information about a specific LSAN zone, click a zone name in the table and then
click the View Details button in the task bar. You can also click the zone name in the tree on the left
side of the window.
The LSAN matrix is mapping of LSAN Zones with the edge fabric they are going to communicate
with. When an LSAN matrix is created in the backbone fabric, only the LSAN zones mapped in the
edge fabrics are displayed in the LSAN Zones tab.