Fabric OS Documentation Updates Supporting Fabric OS v7.0.x
Table Of Contents
- Contents
- About This Document
- Access Gateway Administrator’s Guide
- CEE Administrator’s Guide
- CEE Command Reference
- Fabric OS Administrator’s Guide
- Documentation updates for Fabric OS v7.0.0 and later
- Chapter 2, Performing Basic Configuration Tasks
- Chapter 4, Routing Traffic
- Chapter 5, Managing User Accounts
- Chapter 6, Configuring Protocols
- Chapter 7, Configuring Security Policies
- Chapter 9, Installing and Maintaining Firmware
- Chapter 12, Traffic Isolation Zoning
- Chapter 18, Administering Licensing
- Chapter 19, Monitoring Fabric Performance
- Chapter 20, Optimizing Fabric Behavior
- Chapter 22, Managing Long Distance Fabrics
- Chapter 23, Using the FC-FC Routing Service
- Documentation updates for Fabric OS v7.0.1 and later
- Documentation updates for Fabric OS v7.0.0 and later
- Fabric OS Command Reference
- Fabric OS Encryption Guide Supporting LKM
- Fabric OS Encryption Guide Supporting RKM
- Fabric OS Encryption Guide Supporting SKM and ESKM
- Fabric OS Encryption Guide Supporting TEMS
- Fabric OS Encryption Guide Supporting TEMS
- Fabric OS FCIP Administrator’s Guide
- Fabric OS FICON Administrator’s Guide
- Fabric OS Message Reference
- Fabric OS MIB Reference
- Fabric OS Troubleshooting and Diagnostics Guide
- Fabric Watch Administrator’s Guide
- Web Tools Administrator’s Guide
- Brocade DCX Backbone Hardware Reference Manual
- Brocade DCX-4S Backbone Hardware Reference Manual
6 Fabric OS Documentation Updates
53-1002165-10
show port-channel
3
CEE COMMANDS
Modify the following commands in the Converged Enhanced Ethernet Command Reference
Supporting Fabric OS v2.1.1 (53-1002164-01), published in April 2011.
Under the command show statistics access-list mac, replace the Command Modes entry with the
following:
Command
Modes
Privileged EXEC mode
Under the command show mac-address-table, replace the Command Modes entry with the following:
Command
Modes
Privileged EXEC mode
show port-channel
Displays the Link Aggregation Group (LAG) information for a port-channel.
Synopsis show port-channel {channel-group-number | detail | summary}
Operands channel-group number
Specifies a LAG port channel-group number to display. The range of valid
values is from 1 through 63.
detail Displays detailed LAG information for a port-channel.
summary Displays the summary information per channel-group.
Defaults There are no default configurations for this command.
Command
Modes
Privileged EXEC mode
EXEC mode
Description Displays the LAGs present on the system with details about the LACP counters on their member
links.
Usage
Guidelines
If you do not specify a port-channel, all port-channels are displayed.
LAG interfaces are called port-channels.
Examples To display information for port-channel 10:
switch#show port-channel 10