Fabric OS Documentation Updates Supporting Fabric OS v7.0.x
Table Of Contents
- Contents
- About This Document
- Access Gateway Administrator’s Guide
- CEE Administrator’s Guide
- CEE Command Reference
- Fabric OS Administrator’s Guide
- Documentation updates for Fabric OS v7.0.0 and later
- Chapter 2, Performing Basic Configuration Tasks
- Chapter 4, Routing Traffic
- Chapter 5, Managing User Accounts
- Chapter 6, Configuring Protocols
- Chapter 7, Configuring Security Policies
- Chapter 9, Installing and Maintaining Firmware
- Chapter 12, Traffic Isolation Zoning
- Chapter 18, Administering Licensing
- Chapter 19, Monitoring Fabric Performance
- Chapter 20, Optimizing Fabric Behavior
- Chapter 22, Managing Long Distance Fabrics
- Chapter 23, Using the FC-FC Routing Service
- Documentation updates for Fabric OS v7.0.1 and later
- Documentation updates for Fabric OS v7.0.0 and later
- Fabric OS Command Reference
- Fabric OS Encryption Guide Supporting LKM
- Fabric OS Encryption Guide Supporting RKM
- Fabric OS Encryption Guide Supporting SKM and ESKM
- Fabric OS Encryption Guide Supporting TEMS
- Fabric OS Encryption Guide Supporting TEMS
- Fabric OS FCIP Administrator’s Guide
- Fabric OS FICON Administrator’s Guide
- Fabric OS Message Reference
- Fabric OS MIB Reference
- Fabric OS Troubleshooting and Diagnostics Guide
- Fabric Watch Administrator’s Guide
- Web Tools Administrator’s Guide
- Brocade DCX Backbone Hardware Reference Manual
- Brocade DCX-4S Backbone Hardware Reference Manual
Fabric OS Documentation Updates 13
53-1002165-10
Documentation updates for Fabric OS v7.0.0 and later
4
“----BEGIN REQUEST----” and “----END REQUEST---- (and may include the
strings "x509" or "certificate")
• For Certificate Authorities that request information regarding the type of web server, FOS uses
the Apache web server running on Linux.
Chapter 7, Configuring Security Policies
In the section “Importing CA for FCAP” on page 156, the command is incorrect in step 2. Change
step 2 to the following:
2. Enter the secCertUtil import
–fcapcacert command.
In the section “Importing the FCAP switch certificate” on page 156, the command is incorrect in
step 2. Change step 2 to the following:
2. Enter the secCertUtil import
–fcapswcert command.
Chapter 9, Installing and Maintaining Firmware
In the section “Upgrading firmware on enterprise-class platforms (including blades)” on page 204,
change the second paragraph on the page to the following:
Autoleveling takes place in parallel with the firmware download being performed on the CPs,
but does not impact performance. Fibre Channel traffic is not disrupted during autoleveling,
but GbE traffic on AP blades may be affected. If there is an active FCIP tunnel on the FX8-24
blade, the FCIP tunnel traffic will be impacted for at least two minutes.
Chapter 12, Traffic Isolation Zoning
In the section “Limitations and restrictions of Traffic Isolation Zoning” on page 285, change the
fourth bullet item to the following:
• Two N_Ports that have the same shared area must be configured in the same TI zone. This
limitation does not apply to E_Ports that use the same shared area on the FC4-48 and
FC8-48 port blades.
Chapter 18, Administering Licensing
In the section “The Brocade 7800 Upgrade license” on page 377, in Table 66, the number of GbE
ports activated with an Upgrade license is 6 and not 8. The second row of Table 66 should be as
follows:
TABLE 66 Base to Upgrade License Comparison
Feature Base model Upgrade License
Number of GbE ports 2 6