Fabric OS Documentation Updates Supporting Fabric OS v7.0.x

Fabric OS Documentation Updates 25
53-1002165-10
portThConfig
5
portThConfig
The description of the -action parameter has been updated as follwos:
-action action Specifies the actions triggered by a configured event condition. Valid values
include one or more of the followin actions. If more than one action is
specified, the actions must be separated by commas. To change the existing
config ration of actions, you must first issue the command with the none option to
reset the existing configuration, and then reissue the command with the new
configuration of actions.
slotShow
In the Notes section, the following note to clarify the description of slot 5 in a DCX and in a DCX-4S.
In a DCX-4S, slot 5 is occupied by a control processor blade (Blade ID 50). On a DCX, slot 5 is occupied
by the core blade (Blade ID 52).
On page 927, the description for the -p operand should be clarified to avoid the impression that this
command displays real-time power consumption data. This is not the case. Real-time power
consumption data is displayed for 16G platforms only with the chassisShow command. The data
displayed in the "DC Power Consumption” column and in the summary field "Total DC Power
consumption” indicate the maximum allowed power consumption, not a real-time value.
-p In addition to the basic slot status view, this command displays the following
information about power consumption:
• The maximum allowed direct current (DC) power consumption for the chassis
and individual values for each blade (in Watts). Note that usage for other
components is included but not listed.
On Page 92, change the description of the FAULTY slot status as follows:
FAULTY The blade is faulty because an error was detected. An error code is provided in
parenthesis. This code is for internal use only. To obtain more information about
the error, check for RASLog errors of type EM-<message ID>.
supportSave
Add the following note to the supportSave command and associated man page:
If you use anonymous FTP to run supportSave on a chassis with multiple AP blades, configure the FTP
windows server to allow unlimited anonymous users.
sysMonitor
The description of the -action parameter has been updated as follwos: