Fabric OS Documentation Updates Supporting Fabric OS v7.0.x
Table Of Contents
- Contents
- About This Document
- Access Gateway Administrator’s Guide
- CEE Administrator’s Guide
- CEE Command Reference
- Fabric OS Administrator’s Guide
- Documentation updates for Fabric OS v7.0.0 and later
- Chapter 2, Performing Basic Configuration Tasks
- Chapter 4, Routing Traffic
- Chapter 5, Managing User Accounts
- Chapter 6, Configuring Protocols
- Chapter 7, Configuring Security Policies
- Chapter 9, Installing and Maintaining Firmware
- Chapter 12, Traffic Isolation Zoning
- Chapter 18, Administering Licensing
- Chapter 19, Monitoring Fabric Performance
- Chapter 20, Optimizing Fabric Behavior
- Chapter 22, Managing Long Distance Fabrics
- Chapter 23, Using the FC-FC Routing Service
- Documentation updates for Fabric OS v7.0.1 and later
- Documentation updates for Fabric OS v7.0.0 and later
- Fabric OS Command Reference
- Fabric OS Encryption Guide Supporting LKM
- Fabric OS Encryption Guide Supporting RKM
- Fabric OS Encryption Guide Supporting SKM and ESKM
- Fabric OS Encryption Guide Supporting TEMS
- Fabric OS Encryption Guide Supporting TEMS
- Fabric OS FCIP Administrator’s Guide
- Fabric OS FICON Administrator’s Guide
- Fabric OS Message Reference
- Fabric OS MIB Reference
- Fabric OS Troubleshooting and Diagnostics Guide
- Fabric Watch Administrator’s Guide
- Web Tools Administrator’s Guide
- Brocade DCX Backbone Hardware Reference Manual
- Brocade DCX-4S Backbone Hardware Reference Manual
26 Fabric OS Documentation Updates
53-1002165-10
thConfig
5
-action action Specifies the actions triggered by a configured event condition. Valid values
include one or more of the followin actions. If more than one action is
specified, the actions must be separated by commas. To change the existing
config ration of actions, you must first issue the command with the none option to
reset the existing configuration, and then reissue the command with the new
configuration of actions.
thConfig
The description of the -action parameter has been updated as follwos:
-action action Specifies the actions triggered by a configured event condition. Valid values
include one or more of the followin actions. If more than one action is
specified, the actions must be separated by commas. To change the existing
config ration of actions, you must first issue the command with the none option to
reset the existing configuration, and then reissue the command with the new
configuration of actions.
turboRamTest
Augment the note section of the turboRamTest help pages as follows:
This diagnostic cannot be run on an operational switch. You must disable the switch using the
chassisDisable command before you can run this test. After the test completes, re-enable the switch
using the chassisEnable command.
uRouteConfig
This command is being deprecated as of Fabric OS v7.0.0.
uRouteRemove
This command is being deprecated as of Fabric OS v7.0.0.
userConfig
This command supports user-defined roles in addition to default roles. The -r role operand description
should be updated to reflect this addition.
The statement "Only users with SecurityAdmin or Admin role may execute this command" should read:
"Only users with permissions equivalent to the SecurityAdmin or Admin role may execute this command."
Use the roleConfig --show command to see a list of all existing roles (user-defined and default) along
with command permissions.