Fabric OS Documentation Updates Supporting Fabric OS v7.0.x
Table Of Contents
- Contents
- About This Document
- Access Gateway Administrator’s Guide
- CEE Administrator’s Guide
- CEE Command Reference
- Fabric OS Administrator’s Guide
- Documentation updates for Fabric OS v7.0.0 and later
- Chapter 2, Performing Basic Configuration Tasks
- Chapter 4, Routing Traffic
- Chapter 5, Managing User Accounts
- Chapter 6, Configuring Protocols
- Chapter 7, Configuring Security Policies
- Chapter 9, Installing and Maintaining Firmware
- Chapter 12, Traffic Isolation Zoning
- Chapter 18, Administering Licensing
- Chapter 19, Monitoring Fabric Performance
- Chapter 20, Optimizing Fabric Behavior
- Chapter 22, Managing Long Distance Fabrics
- Chapter 23, Using the FC-FC Routing Service
- Documentation updates for Fabric OS v7.0.1 and later
- Documentation updates for Fabric OS v7.0.0 and later
- Fabric OS Command Reference
- Fabric OS Encryption Guide Supporting LKM
- Fabric OS Encryption Guide Supporting RKM
- Fabric OS Encryption Guide Supporting SKM and ESKM
- Fabric OS Encryption Guide Supporting TEMS
- Fabric OS Encryption Guide Supporting TEMS
- Fabric OS FCIP Administrator’s Guide
- Fabric OS FICON Administrator’s Guide
- Fabric OS Message Reference
- Fabric OS MIB Reference
- Fabric OS Troubleshooting and Diagnostics Guide
- Fabric Watch Administrator’s Guide
- Web Tools Administrator’s Guide
- Brocade DCX Backbone Hardware Reference Manual
- Brocade DCX-4S Backbone Hardware Reference Manual
Fabric OS Documentation Updates 53
53-1002165-10
Chapter
12
Fabric OS FICON Administrator’s Guide
In this chapter
The updates in this chapter are for the Fabric OS FCIP Administrator’s Guide, publication numbers
53-1002154-01, published April 2011, and 53-1002473-01, published December 2011.
•Documentation updates for Fabric OS v7.0.0 and later . . . . . . . . . . . . . . . . 53
Documentation updates for Fabric OS v7.0.0 and later
Chapter 5, Maintaining and Troubleshooting FICON
Under the heading “Configuration restoration in a FICON environment” on page 63, change the
following in Table 5, “Backup and restore in a FICON CUP environment.” Table 5 should have the
following information for ASM bit in the on and off state.
ASM bit Command Description
on configDownload Files saved on the switch that are also
present in the FICON_CUP
section of the configuration file are
overwritten. Files in the FICON section of
the configuration file that are not
currently present on the switch are saved.
The IPL file is not replaced, because
Active=Saved mode is on.
off configDownload Files saved on the switch that are also
present in the FICON_CUP
section of the configuration file are
overwritten. Files in the FICON section of
the configuration file that are not
currently present on the switch are saved.
The IPL file is replaced, because
Active=Saved mode is off. A warning
message is displayed in the syslog to warn
that the IPL file is not being overwritten.