Fabric OS Documentation Updates Supporting Fabric OS v7.0.x

56 Fabric OS Documentation Updates
53-1002165-10
FW-1035
13
Probable Cause Indicates that a Fabric OS state synchronization (FSS) error has occurred for the specified
component. The error code is displayed in the message.
Recommended
Action
Run the supportSave command and contact your switch service provider.
Severity ERROR
The recommended action has been modified for the following message in the chapter, FW System
Messages on page 324.
FW-1035
Message <timestamp>, [FW-1035], <sequence-number>,, WARNING, <system-name>, <Label>, is
above high boundary(High=<High value>, Low=<Low value>). Current value is <Value>
<Unit>.
Probable Cause Indicates that the temperature of the small form-factor pluggable (SFP) has risen above the high
boundary. Frequent fluctuations in temperature might indicate a deteriorating SFP.
Recommended
Action
When other errors such as cyclic redundancy check (CRC) and invalid transmission word (ITW)
occur on the port, replace the SFP.
Severity WARNING
The probable cause and recommended action has been modified for the following message in the
chapter, HSL System Messages on page 425.
HSL-1000
Message <timestamp>, [HSL-1000], <sequence-number>,, CRITICAL, <system-name>, HSL
initialization failed.
Probable Cause Indicates a hardware subsystem layer (HSL) initialization failure. This error is caused by other
system errors.
Recommended
Action
Execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the
supportSave command and contact your switch service provider.
Severity CRITICAL
Documentation updates for Fabric OS v7.0.1 and later
The updates in this chapter are for the Fabric OS Message Reference supporting Fabric OS v7.0.1
(53-1002448-01), originally published in December 2011.