Fabric OS Documentation Updates Supporting Fabric OS v7.0.x
Table Of Contents
- Contents
- About This Document
- Access Gateway Administrator’s Guide
- CEE Administrator’s Guide
- CEE Command Reference
- Fabric OS Administrator’s Guide
- Documentation updates for Fabric OS v7.0.0 and later
- Chapter 2, Performing Basic Configuration Tasks
- Chapter 4, Routing Traffic
- Chapter 5, Managing User Accounts
- Chapter 6, Configuring Protocols
- Chapter 7, Configuring Security Policies
- Chapter 9, Installing and Maintaining Firmware
- Chapter 12, Traffic Isolation Zoning
- Chapter 18, Administering Licensing
- Chapter 19, Monitoring Fabric Performance
- Chapter 20, Optimizing Fabric Behavior
- Chapter 22, Managing Long Distance Fabrics
- Chapter 23, Using the FC-FC Routing Service
- Documentation updates for Fabric OS v7.0.1 and later
- Documentation updates for Fabric OS v7.0.0 and later
- Fabric OS Command Reference
- Fabric OS Encryption Guide Supporting LKM
- Fabric OS Encryption Guide Supporting RKM
- Fabric OS Encryption Guide Supporting SKM and ESKM
- Fabric OS Encryption Guide Supporting TEMS
- Fabric OS Encryption Guide Supporting TEMS
- Fabric OS FCIP Administrator’s Guide
- Fabric OS FICON Administrator’s Guide
- Fabric OS Message Reference
- Fabric OS MIB Reference
- Fabric OS Troubleshooting and Diagnostics Guide
- Fabric Watch Administrator’s Guide
- Web Tools Administrator’s Guide
- Brocade DCX Backbone Hardware Reference Manual
- Brocade DCX-4S Backbone Hardware Reference Manual
Fabric OS Documentation Updates 57
53-1002165-10
Modified messages
13
NOTE
The updates are arranged by the chapter names as they appear in the original document.
Modified messages
The severity has been modified for the following message in the chapter, FW System Messages on
page 373.
FW-1202
Message <timestamp>, [FW-1202], <sequence-number>,, ERROR, <system-name>, <Port Name>,
<Label>, is above high boundaries (High=<High value>, Low=<Low value>). Current
value is <Value> <Unit>.
Probable Cause Indicates that the number of C3 transmit time out frames is above high threshold.
Recommended
Action
Check the target device; it could be slow.
Severity ERROR
The severity has been modified for the following message in the chapter, AUDIT FW System
Messages on page 807.
FW-1202
Message <Sequence Number> AUDIT, <timestamp>, [FW-1202], ERROR, FW,
<event-initiator-details>, <event-location>, , <Port Name>, <Label>, is above
high boundaries (High=<High value>, Low=<Low value>). Current value is <Value>
<Unit>.
Probable Cause Indicates that the number of C3 transmit time out frames is above high threshold.
Recommended
Action
Check the target device; it could be slow.
Severity ERROR