Fabric OS Documentation Updates Supporting Fabric OS v7.0.x
Table Of Contents
- Contents
- About This Document
- Access Gateway Administrator’s Guide
- CEE Administrator’s Guide
- CEE Command Reference
- Fabric OS Administrator’s Guide
- Documentation updates for Fabric OS v7.0.0 and later
- Chapter 2, Performing Basic Configuration Tasks
- Chapter 4, Routing Traffic
- Chapter 5, Managing User Accounts
- Chapter 6, Configuring Protocols
- Chapter 7, Configuring Security Policies
- Chapter 9, Installing and Maintaining Firmware
- Chapter 12, Traffic Isolation Zoning
- Chapter 18, Administering Licensing
- Chapter 19, Monitoring Fabric Performance
- Chapter 20, Optimizing Fabric Behavior
- Chapter 22, Managing Long Distance Fabrics
- Chapter 23, Using the FC-FC Routing Service
- Documentation updates for Fabric OS v7.0.1 and later
- Documentation updates for Fabric OS v7.0.0 and later
- Fabric OS Command Reference
- Fabric OS Encryption Guide Supporting LKM
- Fabric OS Encryption Guide Supporting RKM
- Fabric OS Encryption Guide Supporting SKM and ESKM
- Fabric OS Encryption Guide Supporting TEMS
- Fabric OS Encryption Guide Supporting TEMS
- Fabric OS FCIP Administrator’s Guide
- Fabric OS FICON Administrator’s Guide
- Fabric OS Message Reference
- Fabric OS MIB Reference
- Fabric OS Troubleshooting and Diagnostics Guide
- Fabric Watch Administrator’s Guide
- Web Tools Administrator’s Guide
- Brocade DCX Backbone Hardware Reference Manual
- Brocade DCX-4S Backbone Hardware Reference Manual
66 Fabric OS Documentation Updates
53-1002165-10
Documentation updates for Fabric OS v7.0.1 and later
15
Documentation updates for Fabric OS v7.0.1 and later
Chapter 10, Diagnostic Features
In the section “Diagnostic Port” on page 92, in the fourth paragraph, change the second sentence
from this:
D_Port configuration fails if the port is configured in R_RDY mode, encryption mode, or
compression mode.
To this:
D_Port configuration fails if the port is configured in encryption mode or compression mode.
In the procedure for configuring a D_Port diagnostics session on page 93, add the following note
after step 2:
If you are using D_Ports on active DWDM links, use the dwdm option on the portcfgdport
--enable command. The dwdm option skips the optical loopback test, which is not supported
on active DWDM links.
In the section “D_Port limitations” on page 95, after the sentence “D-Port functionality is not
supported with:” remove the following bullet item:
• R_RDY mode
Appendix A, Switch Type and Blade ID
In Table 22 on page 108, add the following entry:
In Table 23 on page 108, add the following entries:
TABLE 22 switchType to B-series model converter
switchType B-Series switch model ASIC Base switch speed
118 6505 Condor3 16 Gb 24-port switch
TABLE 23 B-series blade model descriptions
Blade ID B-Series blade model ASIC Description
125 FC8-32E Condor3 8 Gb 32-FC ports blade
126 FC8-48E Condor3 8 Gb 48-FC ports blade