Brocade Fabric OS Command Reference - Supporting Fabric OS v7.0.1 (53-1002447-01, March 2012)

Fabric OS Command Reference 813
53-1001764-01
portShow
2
all | tunnel_id
For FCIP-related command options only, specify all to display all FCIP tunnels or
a Tunnel ID between 0 and 7 to display a single FCIP tunnel.
fciptunnel
Displays FCIP tunnel IDs, remote and local IP addresses, remote and local
WWNs, compression status, FCIP FastWrite status, Tape Pipelining status,
bandwidth rate, SACK status, Minimum Retransmit time, Keepalive Timeout,
Maximum Retransmissions, DSCP Marking, tunnel status, tunnel uptime. Refer to
portCfg help for an explanation of these parameters.
Additional optional arguments for fciptunnel include the following:
-perf
Displays additional performance information.
-params
Displays connection parameter information. The display includes the following
High Water Marks:
• Packets in flight
• Round trip time
• Round trip time variance
• Fast retransmits
• Out of order packets received
-credits
Displays FC data path credit data.
-ipsec
Displays IKE and IPSec policy information on IPSec-enabled tunnels. Security
policies are configured with the portCfg command.
-qosmap
Displays the mapping table for VC to FCIP QoS.
-bstr
Displays FCIP TCP Byte Stream statistics on Byte Stream-enabled tunnels
(Deprecated).
-hist
Displays the history of TCP connections.
-snapstart
Resets TCP statistics. The collection of the statistics restarts when this command
is executed. It ends when the -snapshow option is executed.
-snapshow
Displays the TCP statistics that were collected since startup or since the statistics
were reset with the -snapshow command.
mode
Displays mode of GbE port as either "FCIP" or "not configured".
ficon
Displays FICON emulation configuration parameters.
The syntax for portshow ficon is as follows:
portshow ficon [slot/] ge_port all | tunnel_Id [arg] [parm] [-clear]
The following arguments are supported with ficon:
-globals
Displays general FICON controls and statistics.