Brocade Fabric OS Encryption Administrator's Guide v7.1.0 (53-1002721-01, March 2013)

108 Fabric OS Encryption Administrator’s Guide (SKM/ESKM)
53-1002721-01
Viewing and editing switch encryption properties
2
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays. (Refer to Figure 43.)
3. Select a target disk device from the table, then click LUNs.
The Encryption Target Disk LUNs dialog box displays. The time left for auto rekey information is
listed in the table (Figure 74).
FIGURE 74 Time left for auto rekey
Viewing and editing switch encryption properties
To view switch encryption properties, complete the following steps:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 1 on page 14.)
2. Select a switch or encryption engine from the Encryption Center Devices table, then select
Switch/Engine > Properties from the menu task bar, or right-click a switch or encryption engine
and select Properties.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Properties icon.
The Encryption Switch Properties dialog box displays (Figure 75).