Brocade Fabric OS Encryption Administrator's Guide v7.1.0 (53-1002721-01, March 2013)

112 Fabric OS Encryption Administrator’s Guide (SKM/ESKM)
53-1002721-01
Viewing and editing encryption group properties
2
NOTE
You can also select a an engine from the Encryption Center Devices table, then click the
Targets icon.
3. In the Encryption Engine Properties table, locate Set State To.
4. Click the adjacent Engine field and select Enabled or Disabled accordingly, then click OK.
Viewing and editing encryption group properties
Whenever you add or change a key vault address, you must also load the corresponding key vault
certificate. When adding or changing a key vault, if the switches in the encryption group have not
been previously registered with the new key vault, you must add the switch certificates to the key
vault.
To view encryption group properties, complete the following steps.
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box (Refer to Figure 1 on page 14).
2. Select a group from the Encryption Center Devices table, then select Group > Properties from
the menu task bar.
3. You can also select a group from the Encryption Center Devices table, then click the Properties
icon
NOTE
If groups are not visible in the Encryption Center Devices table, select View > Groups from the
menu task bar.
The Encryption Group Properties dialog box includes several tabs that are used to configure
the various functions for encryption groups. All tabs are visible for all key vault types with one
exception; the Link Keys tab is visible only if the key vault type is NetApp LKM. Unless
otherwise specified, the Encryption Group Properties dialog box opens with the General tab
displayed.