Brocade Fabric OS Encryption Administrator's Guide v7.1.0 (53-1002721-01, March 2013)

Fabric OS Encryption Administrator’s Guide (SKM/ESKM) 45
53-1002721-01
Creating a new encryption group
2
Configuring key vault settings for HP Enterprise Secure Key Manager
(ESKM/SKM)
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to “Creating a new encryption group”
on page 40.
Figure 18 shows the key vault selection dialog box for ESKM/SKM.
FIGURE 18 Select Key Vault dialog box for ESKM/SKM
1. Enter the IP address or host name for the primary key vault.
2. Enter the name of the file that holds the primary key vault’s CA key certificate, or browse to the
desired location. This file can be generated from the key vault’s administrative console.
3. Enter the key vault user name.
4. Enter the password you established for the Brocade user group.
5. Re-enter the password for verification.
6. If you are using a backup key vault, enter the IP address or host name, and the name of the file
holding the backup key vault’s public key certificate in the fields provided. The same user
name and password used for the primary key vault are automatically applied to the backup
key vault. The backup address can be left blank.
7. Cl ic k Next.
The Specify Certificate Signing Request File Name dialog box displays (Figure 19).