Brocade Fabric OS Encryption Administrator's Guide v7.1.0 (53-1002721-01, March 2013)

64 Fabric OS Encryption Administrator’s Guide (SKM/ESKM)
53-1002721-01
Configuring encryption storage targets
2
• Right arrow button: Moves a host from the Host in Fabric table to the Selected Hosts table.
• Left arrow button: Removes a host from the Selected Hosts table.
• Add button: Click to manually add host port world wide names or host node world wide
names to the Selected Hosts table.
8. Select hosts using either of the following methods:
a. Select a maximum of 1024 hosts from the Hosts in Fabric table, then click the right arrow
to move the hosts to the Selected Hosts table. (The Port WWN column contains all target
information that displays when using the nsshow command.)
b. Manually enter world wide names in the Port WWN and Node WWN text boxes if the hosts
are not included in the table. You must fill in both the Port WWN and the Node WWN. Click
Add to move the host to the Selected Hosts table.
9. Click Next.
The Name Container dialog box displays (Figure 39). You can specify a name for the target
container that is created in the encryption engine to hold the target configuration data. The
name is only needed when configuring the storage using the command line interface (CLI).
The container name defaults to the target WWPN. You can, however, rename the container
name. Target container names can have up to 31 characters. Letters, digits, and underscores
are allowed.
FIGURE 39 Name Container dialog box
10. Enter the container name. The container name is a logical encryption name to specify a name
other than the default. You can use a maximum of 31 characters. Letters, digits, and
underscores are allowed.
11. Click Next.
The Confirmation screen displays (Figure 40). The confirmation screen confirms and
completes configuration of encryption engines, targets, and hosts.